![how to install clover bootloader how to install clover bootloader](https://cdn.shopify.com/s/files/1/0054/6682/products/1.5-inch-tri-clamp-sight-glass1_grande.jpg)
Note 2: I have tried this with and without AppleIntelFramebufferAzul.kext and AppleKextExcludeList.kext.Ĥ) Copy SSDT for my board into /EFI/CLOVER/ACPI/patched.ĥ) Try to boot using -v and kext-dev-mode=1. That overwrites the generic FakeSMC kext. (Note 1: I am copying in the generic extension kexts first, then the kexts for my board. Graphics: native Intel.ģ) Copy kexts into /EFI/CLOVER/kexts on the USB EFI partition. I got this to boot with 10.9, so I’m trying to figure out what went wrong. I have tried following your guide, but trying to boot from USB I’m not getting past “DSMOS has arrived”. I have a headache just trying to describe what is going on. I’m hoping I can just do option 1, and then using SuperDuper, I can just clone my existing 10.10 installation to the “newly formatted 10.10 Fusion Drive”. I’m new to Clover but I am familiar with Hackintosh, and creating my own Fusion Drive.Ĭorrect me if I’m wrong, but I think these are my options:ġ) Break my 10.9 Fusion Drive into two separate drives again, and re-assemble an entirely new Fusion DriveĢ) Just Reformat “Macintosh HD” from my 10.9 Fusion Drive, and install 10.10 on it (though I’m not sure if Clover will conflict with Chimera’s Apple_Boot/Boot OS X’s helper partitions)Īs of right now, I have 10.10 installed in a separate SSD than the 10.9 Fusion Drive. I’ve been wanting to switch to Clover, for reasons that it seems to be newer/better than Chimera. What’s the best way to create a fresh 10.10 installation under Clover, if I want to use Fusion Drive again (not necessarily “re-using” existing 10.9 installation) I have an existing working 10.9 installation on Fusion Drive, with Chimera.